axle

[ride300exrider]

how hard is it to change an axle i never did it befor so i thought i would ask first
i just got my ne axle yesterday and wanna put in on!!

[Mean250r]

its easy, take off the hubs and the axle nut, bump it out to the left, its self explanitory once u get goin

[tltcracing]

ill explain it as simple as posible.

1. remove wheels (4 bolts each side)

2. remover hubs (2 large nuts on ether side of axle, will need to remove cotter pin)

3. undo 2 large inner nuts on right side (i use a very big adjustable wrench, both nuts turn the same way, if the wrench is on the nut it will turn down to lossen it. the smaller one on the inside needs to be loosned first followed by the larger one. once you turn it far enough you will see a clip in a groove on the axle, remove it and slip the assembly with the two nuts off the axle.)

4. lossen up the chain by undoing the four bolt at the back of the swingarm and trnring the bearing caryer*. pop the chain off.

5. tap axle out to the left side.

6. unbolt the rear sproket from the old axle and bolt it to the new one.

7. insert new axle and reverse steps.

[ride300exrider]

thanks im on it tomorrow after work

ed