PDA

View Full Version : 125 Teather



Andyman17dad
09-28-2006, 07:30 PM
I just got done doing the teather on Andy's 125. Just put a round female connector on the short wire and slip it between the cdi/coil for your ground and then tap the longer wire into the black w white striped wire going to the cdi/coil.

We have Pro Design on the Kasea and the DRX and had to wrap some zip ties around the pull part to make a loop that Andy can pull with little "gloved" hands. We got a Pro Armor one for the Typhoon and it has a T-handle to pull. (much easier.) Something to consider if you havn't bought one yet.

Andyman17dad
09-28-2006, 07:35 PM
Sorry Rob, I hit New Thread instead of relpy!


I am still surprised that these things come with a trick Billit gas cap but don't come with a teather.

Also, check the seal inside your gas cap, Ours has a big tear in it already!
And also be careful in removing the carb, there is a o-ring between the carb and the neck. (Ours is torn)

daddy52
03-11-2007, 09:48 PM
Just an FYI, the wire on the coil is black w/yellow stripe. It's so light that it almost looks white. I also put a new connector on & heat shrink tubing at the coil, the stock one was kind of cheesy!!!

FUTheman
05-03-2007, 11:34 AM
I put a Pro Armor on our 125 and it seems to work well.