Adjusting shift lever on a honda 300ex

[rebelbuggy]

I have a question how do you guys adjust your shift levers on the 300ex for your boots... I went to ride and found out my lever needs to go up but on the 300 if you move it from the stock location it hits the case so do you guys get aftermarket ones that are bent out? or do you bend the stock ones out cause it would need to go about half a inch to clear the case...

If you bend them how do you do it? do you heat it first or what thanks if anyone can answer this

[Sjorge450R]

just move the box too. Then you dont have to bend anything

[Tri-valleyracin]

Grab it and pull it and then un bolt it and move it to were you want, its that easy. I dont think theres any aftermarket shifters for the 300ex.

[rebelbuggy]

Originally posted by Sjorge300EX
just move the box too. Then you dont have to bend anything

ha ha yeah I'm going to move the side of the motor case:eek2:
I noticed on my buddys 400ex the case is made with the case pushed back where the lever goes. so you dont have to worry about it hitting.

[rebelbuggy]

Originally posted by Tri-valleyracin
Grab it and pull it and then un bolt it and move it to were you want, its that easy. I dont think theres any aftermarket shifters for the 300ex.

oh.. Alright

[Sjorge450R]

i was thinking clutch lever. I think moose makes a after market shifter that brings it out more

[rebelbuggy]

Originally posted by Sjorge300EX
i was thinking clutch lever. I think moose makes a after market shifter that brings it out more

oh sorry about the confusiion

[bwamos]

I just bent mine out. ;)

[TJCamro]

I used an MSR YZ250F shifter on mine, works pretty good.