does any one know this?

[ThorRacing37]

how much oil does a 1999 cr125 hold
in its case?

[GPracer2500]

It probably has a figure cast right into the right side case cover. On my 95' CR250 is says 850cm3. It's right under the oil check bolt. Might be in a different spot on a CR125--I doubt it but I'm not sure. Those figures are for after disassembly. After draining it's usually about 100cc's less.

[ThorRacing37]

it saids 650cm3.. i have a mix master and on it its has cm... i know to put in 650cm but what does the 3 mean

[GPracer2500]

1000cm3 = 1000 cubic centimeters (cc) = 1000 milliliters = 1 liter (l)

[ThorRacing37]

so if its 650cm3 how much should i put in?

[GPracer2500]

Remove the oil check bolt and fill it up until oil reaches the bottom of the check bolt hole (when it starts to dribble out of the hole it's full). It will probably end up being about 550-600cc unless your filling it for the first time after having it disassembled.

[ThorRacing37]

ok thanks

[GPracer2500]

I'm assuming CR125s have an oil check bolt. I guess I don't know for sure.

[GPracer2500]

http://www.swedetechracingengines.com/images/cr125_548x480-014c.jpg

See that bolt that's on the clutch cover, to the left of the water pump. I think that's the oil check bolt. May be in a different spot depending on the year of the engine.