help with edelbrock or is it junk

[TTlt250r]

ok heres the deal i just built the top end on my buddies bike and ive got the bike running good but have had lots of problems trying to tune the carb i was wondering if there is anyone out there who has the same mods and could tell me where the have the carb set. the problem is that the bike is running way too lean on the top end. ive run it wide open pulled the clutch killed it and checked the plug it is flakey from excessive burn off i even called edelbrock and ordered the 29 needle as it comes with the 25 stock. the mods are lrd pipe 2 stage hotcam new chain new lower sprocket new piston new intake valves k&n cdi box we always run 110. please help

[krt400ex]

i have been told by a lot of ppl that they r junk, but i don't know

[02440exkid]

Ya I have 1 it's ez to adjust but it hard to get a good reading. Were is you pump shot set to? try to turn it clockwise to richen it up.

[TTlt250r]

are you running the needle that it came with

[02440exkid]

well i got mine used idk wut size is in it but it sems to run a lil rich with my mods.