Flyin-Low
09-01-2006, 05:46 PM
Alright, Heres the story.
I just bought a Rossier pipe, put it on and then rode it once. Ran good.
Then I came home, Cleaned the air filter, and changed the cage to let more air through. And left the lid OFF.
Then I put a CRF450 needle in the carb and set it at 4th clip from the top and installed a 160 main jet and a 48 pilot jet.
I was riding on the trails and my quad stalled and was very hesitant to start up. I never thought anything of it. Then I went further, and it stalled and WOULD NOT START. It turned over, and it would fire, but not start!!!!!
So I called for a ride home, and after the 10 minute drive home I pulled the quad off the truck and tried it again. It started up fine, and idle for a few mins and then stalled and would not start again.
ANY HELP??!!
PLEASE!!??
-Martin
I just bought a Rossier pipe, put it on and then rode it once. Ran good.
Then I came home, Cleaned the air filter, and changed the cage to let more air through. And left the lid OFF.
Then I put a CRF450 needle in the carb and set it at 4th clip from the top and installed a 160 main jet and a 48 pilot jet.
I was riding on the trails and my quad stalled and was very hesitant to start up. I never thought anything of it. Then I went further, and it stalled and WOULD NOT START. It turned over, and it would fire, but not start!!!!!
So I called for a ride home, and after the 10 minute drive home I pulled the quad off the truck and tried it again. It started up fine, and idle for a few mins and then stalled and would not start again.
ANY HELP??!!
PLEASE!!??
-Martin