Dead on trail, HELP FAST PLEASE!!!

[Flyin-Low]

Alright, Heres the story.

I just bought a Rossier pipe, put it on and then rode it once. Ran good.

Then I came home, Cleaned the air filter, and changed the cage to let more air through. And left the lid OFF.

Then I put a CRF450 needle in the carb and set it at 4th clip from the top and installed a 160 main jet and a 48 pilot jet.

I was riding on the trails and my quad stalled and was very hesitant to start up. I never thought anything of it. Then I went further, and it stalled and WOULD NOT START. It turned over, and it would fire, but not start!!!!!

So I called for a ride home, and after the 10 minute drive home I pulled the quad off the truck and tried it again. It started up fine, and idle for a few mins and then stalled and would not start again.

ANY HELP??!!

PLEASE!!??

-Martin

[400eXr1d3rZ]

You might have something in your jets or float. Check that.

[Flyin-Low]

Whats the best way to do that?

Take the bottom off the carb and clean it out?

-Martin

[Flyin-Low]

Any other thoughts before I go out to the shop?

-Martin

[4ABURN]

If this is an 06 the 48 pilot is to rich . When hot it will not start good if at all. ( sound the same) mine has a 45 in it and it is great. Don,t forget about the air screw.!!!!!!! My 2 cents :D

[Abrannan19]

another guy on here had that same problem..I dont remeber what the outcome was but I remeber that it wouldnt fire with the ES but it would pull start..