LSR - broke sprocket hub removal?

[dvrman]

Hi, I have an LSR axle with a sprocket hub that came already installed on the axle. This is on a 400ex by the way. So, I bent the sprocket and the hub and need to remove both and replace. I got the sprocket off no problem, but the hub is on there good. Are these hubs pressed on? Will I need to take it in to a shop to have it removed and a new one installed?

Thanks

Dan

[deathman53]

they are pressed on, you need to press it in to remove the circlip, then press it out, press in the new sprocket hub, install the circlip and press it out abit to seat the circlip, I did a few lsr ones, its not real hard. I've had access to a hydrolic press also.

[dvrman]

OK, one more question. I have a stock hub off my old axle. Will that fit on my LSR or do I need an actual LSR hub?

Dan

[deathman53]

I don't think so, but it might, you would have to direct that to lsr.