flowmaster for a GMC..

[shftmx300ex]

I just got my 1993 GMC Sonoma V6 4.3L and i was wondering if anybody new about were i can get a flowmaster exhaust installed any were in the massachusetts area. heres some pics of it..
http://i7.tinypic.com/2192x35.jpg
http://i7.tinypic.com/2192ygz.jpg

[Hondadudeehhhh]

do it yourself, its very easy and take no more than 3 hours. Order a muffler and just get the pipes bent for you. It will save you a lot of time.

[brian-250]

The do it yourself stuff isn't as easy as thought, to get it done right anyhow. I'm a mechanic for the entire neighborhood up here and Ive found the easiest way to do get it done is buy mufflers and tips and take it to a muffler shop and say run me some pipes! just a tip.

[sakirocket28]

i used to have a 93 4.3l sonoma too. i couldnt believe the difference with the flowmaster on mine. i put it on myself, i cut the exhaust off right after the cat, leaving about 3 inches for me to weld the muffler on. when i was done weling it on, i ran a pipe that turned down right before the back axle. good luck!:)

[shftmx300ex]

Originally posted by sakirocket28
i used to have a 93 4.3l sonoma too. i couldnt believe the difference with the flowmaster on mine. i put it on myself, i cut the exhaust off right after the cat, leaving about 3 inches for me to weld the muffler on. when i was done weling it on, i ran a pipe that turned down right before the back axle. good luck!:)

thanks, i was thinking of making side exit exhaust and make it come out right in front of the passenger side rear tire

[400exrida06]

Originally posted by shftmx300ex
thanks, i was thinking of making side exit exhaust and make it come out right in front of the passenger side rear tire



You want them to come out the side some what like this?

[coolex]

what town in mass do u live in, there are plently of shops around mass, but like mentioned above buy the flowmaster muffler, bring it to the shop and tell them to install it, it will save u alot of fustration, unless you have afriend with a car lift:macho

[ELewandowski]

I had a 91 with the 4.3. A flow will sound nice. I had turn downs right after the flow, and no cat.

[CDALEMX301]

Hey man....I got the exhaust on my 98 GMC 5.8 done at Lou's Custom Exhaust in Waltham but i recently heard they have a shop in Worcester too...Lifetime warrenty on everything but the tips and its all custom bent

[shftmx300ex]

Originally posted by 400exrida06
You want them to come out the side some what like this?
yeah but instead of a square shaped tip 2 round tips, one on each side

[shftmx300ex]

Originally posted by coolex
what town in mass do u live in, there are plently of shops around mass, but like mentioned above buy the flowmaster muffler, bring it to the shop and tell them to install it, it will save u alot of fustration, unless you have afriend with a car lift:macho

i go to a tech school and im in auto tech, i could install it myself but i need the tubes bent

i JUST put flowmasters on my 89 s-10 4.3 litre. i went with a 2.5 inch system from the Y-pipe back. for $300.

sounds way better, mainly in the low rpm's. at 1500 it purrrrrrrrs. anything about 2 G's and it sounds almost stock.