Pro Armor Kill Switch Wont Hook Up Right??

[WheelieMan4]

Well first of all, It wont tighten down on to the bars...so it moves very easily...I must have stripped them out to, because 2 of them get tight, but the other 2 just keep spinning.

And then for hooking it up...I have it grounded to the plastic mount, but then for the other wire...All I have to do is just splice into the BLACK wire with a YELLOW stripe? Can Somebody get a pic of how theres is hooked up? Thanks...

[bmurray]

sounds stripped. try wrapping the bolt with teflon tape and just snug it up. this link below will walk you thru it with pics.

http://atv.off-road.com/atv/article/articleDetail.jsp?id=217454

[Crazy lil punk]

i couldnt figure it out when i did mine, so i took it to the shop

[nosliw]

Originally posted by Crazy lil punk
i couldnt figure it out when i did mine, so i took it to the shop

did they tell you what was wrong?

[WheelieMan4]

Well at first I couldnt get both spacer things to work, So I only had 1 in there...I took it back off today and tried again and got it to work, it doesnt move at all now...and didnt have to tighten near as far. I will check out that link posted above...Thanks.

[WheelieMan4]

Started to look at that site, and it doesnt have any words...Im still confused.

[Aztrx400]

And then for hooking it up...I have it grounded to the plastic mount,


You can not ground to plastic.

[miller821]

Hooked mine up with help of this thread!
http://www.exriders.com/vbb/showthread.php?s=&threadid=32546

[WheelieMan4]

Originally posted by Aztrx400
You can not ground to plastic.

i know, but its touching the bolt...and the bolt is going to the frame...

[bmurray]

sorry, try this one.
http://atv.off-road.com/atv/article/articleDetail.jsp?id=192237&searchString=kill%20switch

[WheelieMan4]

Hey thanks alot, but I already got it today...Thanks anyways