Laeger's YZ Full MX in VA

[laeger426]

Here is for sale my Laeger's 426 hybrid.

Laeger's narrow chassis
Laeger's protrax complete front end +3+1, a-arms, spindles, steering stem and tie rods
Laeger's swing arm with LS bearing carrier
Denton stabilizer
Nacs front hubs
Lonestar rear hubs
Lonestar axle
Elka Quadrate LT front shocks 185 lb compression and rebound adjust
Elka dual rate rear compression and rebound adjust 185 lb
Honda 300EX thumb throttle
Honda plastic with Legacy graphics
Quadtech hood, tank cover, and radiator shrouds
Alluminum airbox
Oversized radiator
RTC clutch and brake lever
Azonic bars
AC propeg nerfs
TC full exhaust
Blingstar bumper
AC grab bar
2000 YZ 426 engine bored and nikasiled by Max Power to 445cc


Asking $6,000.00 OBO or possible trade for production 450r or yfz450. If interested, send a PM or call Chris at (434) 575-5383.


http://i96.photobucket.com/albums/l184/kaitlyngrey/Quad%20Pics/QuadPic.jpg
http://i96.photobucket.com/albums/l184/kaitlyngrey/Quad%20Pics/100_2062.jpg
http://i96.photobucket.com/albums/l184/kaitlyngrey/Quad%20Pics/100_2061.jpg
http://i96.photobucket.com/albums/l184/kaitlyngrey/Quad%20Pics/100_2060.jpg
http://i96.photobucket.com/albums/l184/kaitlyngrey/Quad%20Pics/100_2059.jpg
http://i96.photobucket.com/albums/l184/kaitlyngrey/Quad%20Pics/100_2057.jpg

[jrspawn]

Hey, just wandering who had converted the frame over for the yz?

Thank you
Justin

[jrspawn]

Hey, i checked on some of my old Laeger YZ's, and yours is def. a conversion, a pretty good one though. The true laeger YZ frames have a small intend in the frame under the right side oil line where it bolts to the engine for the bottom motor mount. The motor mounts are different. The chasis has the mounts for the oil tank, one side of the oil tank mounts is a straight round tube, the other side is slightly bent. There is a tube/brace that runs vertical almost where the front of the nerf goes, then underneath the motor mount. The YZ engine bolts through the swingarm, the yz chasis has a laeger yz swingarm, it also offsets the rear end two inches to the right i believe so you have to space your axle a little wierd, the yz chasis also has a different sub frame, the mounts are higher on the frame i believe and im almost possitive all the yz chasis were built wiht flip tops. Ill post a couple pics that will hopefully show what i was talking about.

Thank you
Justin

[jrspawn]

.

[jrspawn]

..

[416exmx]

I noticed it was a conversion also. The motor sets too far forward and too low in the frame from not mounting through the pivot bolt. Like Justin said, it however is a clean job.