crank install

[danbobsR]

I need some input on maybe installing a crank myself I got it apart and I got new bearings and my new crank should be here tommorrow Ive been disputing on whether or not to do it any input would be nice I just dont want to damage anything in the process of squeezing it in the cases

[BLACKeR]

youll need a puller to get your crank into the case. you cannot beat it in with a hammer. if you freeze the crank and heat up the bearings its not too hard to get in but i would not do it without some kind of puller.

[250r4life]

freeze the crank and heat up the bearings, and see if you are able... worst case scenario you could take it to the shop you were thinking about doing anyway and have them finish it if you are unable to get it to go all the way...

[45 lt80]

Where can you get the puller. I got my cases a part tooo...
I was going to freeze the crank and heat the bearings up.

45lt80

[Rich250RRacer]

Originally posted by 45 lt80
Where can you get the puller. I got my cases a part tooo...
I was going to freeze the crank and heat the bearings up.

45lt80

I believe the puller is only available from Honda. That's where I got mine.