Help with number plates...

[WheelieMan4]

Take a look at this please!! Thanks!

http://www.exriders.com/vbb/showthread.php?s=&threadid=243759

[tltcracing]

if you have the stock grab bar i would leave the rubber spacers in and drill holes acordingly. for the AC, if it fits in then drill the holes and zip tie it but if it doesnt fit you might have to cut it to get it to fit in ther. as far as 4 goes... 44, 444, 04, 40, 14, 41, 141, 411, 234, 420, 45.

[WheelieMan4]

Thanks alot, I was thinking like 406 cuz thats what my engine is considered i think...Yes its the stock grab bar, I will drill some holes and just zip tie it or use a bolt?? what do you think? Thanks

[Phills450r]

zip ties.. my friend used bolts on his and his plate cracked. put zip ties through a new one and havent had any problems on his or mine. we run 2 zip ties through each hole just incase ;)

[theTman]

Originally posted by WheelieMan4
Thanks alot, I was thinking like 406 cuz thats what my engine is considered i think...Yes its the stock grab bar, I will drill some holes and just zip tie it or use a bolt?? what do you think? Thanks

[Phills450r]

that works.. i had mine turned the other way though

[WheelieMan4]

Originally posted by theTman


how did you get that to work, when I took off both of those black things that hole is like cut away so the way you have those zipties would just come right out?

[theTman]

Originally posted by WheelieMan4
how did you get that to work, when I took off both of those black things that hole is like cut away so the way you have those zipties would just come right out?

if you look at yours...it looks like a little hook...bang it up with a hammer to make it a closed hole...and there ya go

[WheelieMan4]

Originally posted by theTman
if you look at yours...it looks like a little hook...bang it up with a hammer to make it a closed hole...and there ya go

ic ic, ok thanks alot...i will try that this weekend when i get the number plates