Pro Armor Kill Switch

[Taz14racer]

Can anybody give me instructiosn on how to install a proarmor kill switch for a 03 Z400?


Oh and anybody got any pics of shaved fenders on a Z400

[GooseZ400]

dont have pics but will describe to you the best that I can.

1: Position kill switch on handlebars were youll want it to be placed

2: Run the longer of the 2 wires to the right side of the machine down somewhere near your clutch cover and let it sit in the air

3: Right side if you were sitting on it. Underneath the gas tank lies your coil. There's a little black wire that is attached w/ an electrical blade connector. Cut the connector off!!!. Run your longer line and this line into a new blade connector and crimp these together. Go ahead and silicone where the wires are to prevent water from reaking havoc. Place the connector back onto the coil.

4: Take your shorter wire and ground this to the frame. Your pastic mount on the left side is a good location. BE SURE TO USE AN ELEC. EYELET AND ALSO TO SILICONE THIS AS WELL TO KEEP WATER OUT.
Start your quad and pull the cord. Should kill it. W/ the cord removed try to fire up your z, It shouldn't fire up

[tintman]

i have one for my 350 raptor
no instructions!
it has 1 black wire and 1 white wire
could i tie it in with the oem kill switch somehow?