View Full Version : what bore size to get
6858-400ex
07-02-2006, 04:51 PM
i want to trick out my 400ex i want to make it as fast as possible
i need some help on what bore size to get. some guys say a 416 accelorates faster than the 440. i want power from bottom to top.
give me a list of what to get and what bore you recomend. i do alot of trail riding, and i like to drag race,and go to the dunes. i have hotcams stage 2, hmf slipon, k&n. i want to be able to compete with faster quads
b440ex
07-04-2006, 01:09 PM
bulid a stoker motor a 416 or 440 wont keep up
sixer3
07-04-2006, 02:44 PM
do a powroll 440 storker i think its a 426 or 416 piston with a 4mm stroke while your in there, get a heavy duty rod and go 12:1 compression amd a hotcam stroker cam with heavy duty head studs( dont forget to run race-gas, make your gearing a bit taller, and go smoke some 450s (most)
now your probably thinking "im not a **** bank"
in order to be serious about going fast, it is going to cost money....there are cheaper more common ways but you'll never see the horses out of a drop in piston with a stage 2 hotcam that you will with a well-built stroker....or otherwise....goodluck....dont forget a bigger carb too :) a lot of people like 400$ fcr:)
Wheelie
07-04-2006, 09:44 PM
Go with the powroll 440 stroker, killer setup.
My setup: Powroll 440 stroker w/HD Rod, stage 3 Hotcam, P&P head, CRF cam chain, stock carb so far. This thing has insane low end torque and pulls hard to the rev limiter.
This setup does very well against the new machines.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.