350x conversion question

[heath720]

i bought a 350x/250x conversion a while back and i want to paint the frame. how the hell do u get the motor out of the frame. thanks for your help.

[Blue250X]

Do you have all the engine mounts unbolted? If not first you have to unbolt the engine from the mounts. Make sure you get them all, then its kind of hard to get the actual engine out of the frame. Its easier to bring it out the left side, and you kind of have to tilt it and play with it to get it to come out.

[Sjorge450R]

Originally posted by Blue250X
Do you have all the engine mounts unbolted? If not first you have to unbolt the engine from the mounts. Make sure you get them all, then its kind of hard to get the actual engine out of the frame. Its easier to bring it out the left side, and you kind of have to tilt it and play with it to get it to come out.


the only way out is from the left side. Make sure you take your nerfs and foot pegs off too.

[Notfast3nuf4m3]

Its deff hard to get that motor in and out of the frame.Kinda like fititn 10lbs of $hit in a 5lb bag.When doing my conversion the motor must have been in and out of the frame about 20 times.And its still not in for the last time yet damne service honda.

[heath720]

thanks for your help everyone.

[Blue250X]

Originally posted by Sjorge300EX
the only way out is from the left side. Make sure you take your nerfs and foot pegs off too.

if i wanted it out bad enough, itd come out any way i told it to:devil: