Scott-300ex
06-26-2006, 06:45 PM
I went riding yesterday and this week I am going threw the whole quad. So I went to adjust the chain and I figured you just loosen the 4 allen screws then hit the eccentric with a screw driver and a hammer around clockwise(from the left side of the bike). So I did that and it wouldn't go anymore, then it was in nuetral but it was real hard to turn the tires. So I lifted it up and hit it back the other way and somehow it got tighter and its by where it was originaly. The tires and axle seem to move fine now.
Now another question is-Is the mark on the swinger(little pinhole) supposed to line up with the mark on the chain adjuster eccentric(1/8 bump)?
Now another question is-Is the mark on the swinger(little pinhole) supposed to line up with the mark on the chain adjuster eccentric(1/8 bump)?