400ex rear brakes

[bc_sandlin]

ok. i changed my pads the other day. the brakes were working a little but not as good as they used too. so i bled them and now there getting no pressure at all. i mean u can push the back break lever all the way down and the pads do not move or nothing. its got dot4 brake fluid in it. wat could be the problem? o yeah ive got aftermarket brake lines too.

[spanky101]

maybe some air in the lines?

[JOEX]

I'd say the master cylinder needs a rebuild. The kit is 'about' $30. And a set of 90* snap ring pliers will make things easier;)

[bansheemorphine]

where the line bolts on there is two little like brass washers make sure there is one on top and one on bottom and take them and clean them and the surfaces they touch there could be a piece of dirt in there also look for fluid dripping out of somewhere most likly the caliper