need help asap!!

[madfastbanshee4]

i finally got my cylinder and wiseco piston kit after two weeks and i go to check the ring side clearnce and the end gap and the rings don't even fit, there is no end gap at all and there super tight. my cylinder is on its stock bore and has just been honed any sugestions? on how to get them to fit?

[JW450R1]

try calling weisco.can the ring fitt into the cyclinder?.

[madfastbanshee4]

barley. only if u sqeeze it. could they possibaly have gave me the wrong rings?

[1fst400]

sometimes you adjust the gap with a file. There are usualy instructions in the box with the piston as to what to set it to.

For the regular guy, if it fits in there... its good.

[madfastbanshee4]

i had it orderd threw a local shop and the label reads Clear: 0.0020(0.051mm) and i told the guy to order the std bore one and its looking like he have me the wrong one