A-Arm Repair

[Resq]

01' 400ex, stock arms. The bearings and seals are removed. Looking around the site, and other company sites, I see allot of urethane bushings for replacement. Cheap too. Knowing you get what you pay for, I need some help from members that have done this repair with urethane and or oem replacement parts. Pros and cons?

I started to buy pivot works, and seems to have all the parts except the clips that are re-used. Any input is appreciated.

R.

[duke416ex]

I was looking at replacing those on my 400. I would definately go with a needle bearing and from what I remember, pivot works was well over half the oem stuff. I hav eused pivot works before and had good luck with them.