adinocr7
06-19-2006, 09:45 AM
Had a little mishap a few weeks ago and winded up needing a new tie rod. Well I purchased a complete set and swapped out the old.
What is the ideal setup when adjusting tie rods on your wheeler? Are the front tires supposed to be: neutral, toed in or toed out? I read that the correct setup was to have the front tires at a slight toe in; appx 1/4 inch. (In other words the fronts of the front tires are 1/4 inch closer then the backs of the tires) I did this and went out for a few hours of riding over the weekend. I felt that at low to medium speeds the machine felt a little "darty" in the front. If anyone has any advice it would be greatly appreciated.
What is the ideal setup when adjusting tie rods on your wheeler? Are the front tires supposed to be: neutral, toed in or toed out? I read that the correct setup was to have the front tires at a slight toe in; appx 1/4 inch. (In other words the fronts of the front tires are 1/4 inch closer then the backs of the tires) I did this and went out for a few hours of riding over the weekend. I felt that at low to medium speeds the machine felt a little "darty" in the front. If anyone has any advice it would be greatly appreciated.