burgard 14mm ball joint install issues

[drifterx]

I'm putting on my new burgard +3's on my 300ex, and everything has gone smooth so far. I tightened down 3 of the 4 ball joints on the a-arms, and the 4th one will just spin. The stock ball joints had a 14mm wrench slot next to the boot to grab hold of, but i can't seem to find one on the burgards. I searched, but can't find anything. Anybody got any tips? Thanks a bunch, i appreciate it! :)

[Pappy]

Use a rubber mallet and hit the ball joint into the spindle. This will seat the spindle and keep the ball joint from moving

[drifterx]

Thanks pappy! I'll give that a shot. :D