raptorman2001
06-08-2006, 06:19 AM
I have a very nice honda 400ex for sale it has lots of aftermarket and everything runs and rides fine...the only down falls are the front bumper has a little crack in it about 1/4"long and the plastic has a 2in long crack that has been stitched up and that is the only problems! here are the mods you can reach me at this # 1-765-309-1252! im asking 3600 OBO...HAVE TO SELL QUICK BUYING A 450R SO MAKE OFFERS: WILL TRADE FOR A 450 OR MX READY 400EX OR ANY TYPE Z400!
mods:
houser +1 arms
houser +1 steering stem
elka tripple rate suspension (front & back)
renthal handle bars
leager +1.25 swing arm
itp t9 rims with race rings all the way around!
handguards
gripper seat cover
t4 exaust (full) dyno tuned and jetted
aftermarket race clutch purch
sticker kit
ims front bumper
ims rear bumper
ims end kickers on foot pegs
walsh gusset kit (for the frame) installed by walsh:
renthal handle bars
moose hand gaurds
lonstar carrier
prm skid plates
pro design kill switch
ims oversised gas tank
barnette racing clutch
trail tech led lights
meijer hood
pro armor grab bar
pro armor bumper
razor 2's all the way around
wave brake rotor
new baldwin rear sprocket
double oil cooler (not homemade bought)
and more....
mods:
houser +1 arms
houser +1 steering stem
elka tripple rate suspension (front & back)
renthal handle bars
leager +1.25 swing arm
itp t9 rims with race rings all the way around!
handguards
gripper seat cover
t4 exaust (full) dyno tuned and jetted
aftermarket race clutch purch
sticker kit
ims front bumper
ims rear bumper
ims end kickers on foot pegs
walsh gusset kit (for the frame) installed by walsh:
renthal handle bars
moose hand gaurds
lonstar carrier
prm skid plates
pro design kill switch
ims oversised gas tank
barnette racing clutch
trail tech led lights
meijer hood
pro armor grab bar
pro armor bumper
razor 2's all the way around
wave brake rotor
new baldwin rear sprocket
double oil cooler (not homemade bought)
and more....