cutting plastics????????

[Hondaboy007]

how is everyone cutting their plastics and what tool are they using, anyone done it and did it turn out good. im thinkin bout doin it,,,

[fast250r]

A dremmel or a sawzaw will work good.

[Caseys 300ex]

When i cut my plastic i used a dremmel with a grinder tip on it and it worked great. The only problem was it melted the plastic. So u have to sand it afterwards.

[GooseZ400]

an air saw would work really well

[mr300ex]

i used an airsaw and it worked really well, then i took my buddies air wheel and it had like soft steelwool on it and smoothed them down.

[Latemodel32]

dremmel,then steel wool

[gbcap]

razor blade. exacto knife. then sand it down to the finish you want. those are less likely to get wild and crazy lines if you slip.

[Iliketogofast]

After you finish with whatever you choose to use, sand the edges with a heavy grit sand paper, then a fine grit and hit it with a heat gun when you're done. It gives a really nice factory look.

[gtilley45]

Originally posted by Iliketogofast
After you finish with whatever you choose to use, sand the edges with a heavy grit sand paper, then a fine grit and hit it with a heat gun when you're done. It gives a really nice factory look.

Excactly what I was gonna say.

[PowerJunkie]

go to the HOW TO section. they have a great thread on this topic

[Moto250X_Rider]

i used a dremmel on mine with a grinding bit...sanded it some...and took a lighter to it looks good could never tell... just do slip when cutting lol

[DOHC]

Air Dremmel worked great for me