'05 450R cylinder

[buckeyenut]

I have a cylinder off my '05 450 that I don't need anymore.. The criss-cross milling marks are still in it but there is damage in four places in the plating. Lost a drain plug at a GNCC and ran it out of oil without knowing till it locked up. I did check to make sure it didn't get warped or whatever from the heat and it still seems good. Put it on a marble top dresser, went around it trying to slide a piece of paper under it, didn't fit anywhere. Spun the cylinder a bit, just to be sure, paper still wouldn't fit anywhere. Did this on both sides, as far as I can tell, it's still completely fine. I have pictures of the damage, just not smart enough to put them on here. I am 99% sure it would still work fine for a bore kit as the damage is not deep into the cylinder walls at all. If you want to see the pics you can talk to me on AIM and I can send them to you on there.. My SN on there is t rocketboy rex ... BTW I'm trying to get $110 shipped for it.

Thanks,
Rex