wiring tether kill switch

[hoax]

i bought the tusk kill tether which is the same as the pro armor kill. and i was wondering how in the world do i wire it? i know i have to groung the short wire.

btw its for a 400ex

[DieselBoy]

im wondering does the killswitch complete the circuit to run, or interrupt it?

[jsmith2232]

With the teather attached it will close the circut and once it's pulled it opens it. I hooked mine up by grounding my short wire to the frame by putting in on a screw that holds the plastics on and the long wire I spliced it into the black wire with a yellow stripe on it that goes into the rev box under the front plastics, took about a half of an hour and was a piece of cake.

[hoax]

I just recieved instructions from them and it says to put it on the pulse trigger lead. is this the black wire with yellow?

[DieselBoy]

if i pull the wires for the killswitch - do i need to ground one ? if so which one.

[jsmith2232]

I'm not sure about the pulse wire but i ran a search on here and that was the way most of the guys hooked theirs up and it works + it's easy just go to an auto store and get a wire splicer and you won't even have to cut the black and yellow wire.

[DieselBoy]

does one of the wire's to the kill switch need to be grounded?

[jsmith2232]

Yes on the pro armor the long goes to the black wire with a yellow stripe and the short wire is grounded on the frame

[DieselBoy]

what color wire needs to be grounded on the stock kill switch?