03 JB Houser Laeger Axis CRF450 quad.

[416exmx]

03 JB Racing Converted frame
03 CRF450 motor, carb, wiring
Houser +3 LT a-arms
Custom Axis tripple rate dual adjust fronts
Laegers +1.25 swingarm
TCS dual rate dual adjust rear
Burgurds chrome +1 stem/clamp (new)
RPM +4 axle
RPM carrier
RPM anti-fade
Baldwin exhaust
PWR radiator
AC bumper
AC pro-pegs
Renthal bars/grips
Acerbis handguards
Fastline brake lines
Laker Custom plastic
Goforit graphics
New Honda seat
Douglas rolled lip fronts with kenda mx
Douglas beadlock rears with maxxis razors
OMF shrouds and seat latch
Billett gas cap
Stainless bolt kit
DID chain
Hinson brake petal
Walsh kickstart extender
YZ kick lever

Motor has newer top-end and valves were adjusted. Shocks were serviced at Loretta Lynns last fall. ALL NEW bearings/seals. NEW a-arm bushings/sleaves and NEW upper/lower ball joints, new water pump seal. Everything has NEW powdercoat. This quad is 100% ready to go. Only thing it needs is a rider...... $5750 or might be open to trades.

farmbig_01@hotmail.com

[416exmx]

2

[416exmx]

3

[416exmx]

4

[416exmx]

5

[416exmx]

6

[theTman]

eh i doubt this bu worth a try...

1986 310R built by CT, it needs a new head which i just sent out the MO for..then it just needs new bars, throttle cable, airscoops which i will be makin in the next few days, a new pipe (this one is junk) and a coolent overflow bottle, the frame also has a slight crack which i will be getting welded this week, just got a new clutch gasket and a water pump fan, hasnt been started in 2 years, bought it as a project

let me know..

LSR +2+4 axle/carrier/locknut/sprocket hub
ac propeg nerfs
8 in douglas rims on 18 inch fast trekkers (i think one needs to be reset on the bead..doesnt hold air)
stock 400ex front shocks on stock a arms
moose throttle
SRP ezpull clutch lever
fibe industries hood and rear brake reseviour guard
full race cut maiers

[theTman]

one more

[foxrichie_16]

still got her

[JACK1021]

i belive that i saw this quad for sale on ebay

[416exmx]

Still for sale.