I Need Washers!!

[WickedATVer]

I'm well into my rebuild to 426 bore. It was needed because it wsa smoking like it was just going to blow. Took it apart and it became apparent that someone was in there before me. parts missing parts installed wrong wrong parts. but now I've got all that corrected I need the four 10mm washers that go on the bolts that hold the cylinder down. were can I get these QUICKLY !!!!! or am I going to have to order through my closest honda dealer? thanks

[GPracer2500]

I can't think of anywhere you'll find those other than from Honda. If memory serves they are a very thick aluminum washer--not exactly run-of-the-mill.

You might search for a specialty fastener shop in your area but if you don't have a washer to match-up with getting the exact size (thickness) will be tough.

good luck

[JOEX]

Isn't one of them a different size than the other three?

[JOEX]

I think this is the one that goes in the front:
90453-KAS-900 WASHER (10X25X4)

The other three:
90453-KCY-670 WASHER, PLAIN (10MM)

[WickedATVer]

no see the spot that has three that 10mm washers and the one bigger differant one is where the head bolts down to the jug. I need four of the 10mm ones becauce those are the same as the washers that go one bolts that go into the holes that are in the jug. (sorry if i lost any one). Either way I just have to wait it out and get them from Ronnies.com or some where.

just to be clear the washers I need are the ones that are described as "WASHER / PLAIN 10mm"

[JOEX]

Sorry, I misread your post:(

This is the washer for the cylinder bolts, it's a different part number :confused:

90410-KR0-000 WASHER (10MM)

[WickedATVer]

JW where are you geting your info from and where would you go to order the washers?

[JOEX]

Originally posted by WickedATVer
JW where are you geting your info from and where would you go to order the washers?
http://www.servicehonda.com/hard%20parts/atv/trx400ex%2099-04/trx400ex%20frames%20page.htm

[JOEX]

I haven't bought anything from them in awhile but they used to have an $8 minimum shipping charge so those washers could be quite expensive if that is all you order;)

I get most of my stuff from C&D Racing. Colby just may have some laying around:)