henryhenry
05-05-2006, 11:57 AM
can anyone give me a starting point on jetting a 310 with an 38as carb mx porting , sparks mx pipe
Jester
05-05-2006, 07:07 PM
sorry, the other thread dropped off my radar...
I'd start at about a 190 middle clip 1.5 turns.
the PJ you'll have to fiddle with the screw to figure out what you need. IE if the screw is farther out then get a different jet, I forget what direction you go though..
Do some plug chops with that jetting, and go from there.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.