front end alignment?

[chevy19]

when i get my ex in 3rd gear the handlebars shake really bad. is this the toe in how do you guys align the front end?

[CannondaleRider]

Usually...handlebar shake is caused by something out of balance/true.

But, since you asked, I toe in my bikes 1/8"

[JW450R1]

try lifting the quad off the ground and spinning the front wheels to see if their bent....then try running it to see is something in the rear is bent.wheel,hub,,axle,and or rear axle bearing bad.

[jeremy_283]

SLIME CAUSED THAT CRAP ON ME ........ but i accidently followed their lamo instruction and used one whole bottle for each tire..... now i use only half a bottle

[IrideMHSC]

to alighn the front end take like cinder blocks and place them next to the rear tires, then find something long enough that you can use a straight edge to go from the back tires to the front. when you get the front tires to match back ones with the board fully touching both tires on both sides then adjust your tie rods to your desired toe in amount