View Full Version : Houser balljoint removal ?
maxamillion
04-23-2006, 08:47 AM
I have Houser LT a-arms and I want to remove the lower balljoints. I took the snap ring out on the bottom side of the lower a-arms and it looks like the balljoint should be pressed out the bottom. Anyone done this before and are there any tricks? Which way the the joints come out?
Thanks , Max
YZ400EX
04-24-2006, 11:58 AM
Just take the retaining clip out and put the arm on a block of wood and lightly tap it out of the bottom with a mallet or hammer..They will just slide out..shouldnt be real hard..and then with installing them kinda do the same thing, but grease the inside a little so it slides better..
maxamillion
04-24-2006, 05:24 PM
OK thanks, ill give it a try
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.