Break in tips for new cam, piston, rings and bore?

[Honda4ooEX]

I just put on a 416 kit and I have a new cam, piston and rings, and bore. How do you guys go about breaking them in and how long till I can really start pushing my new motor to its limits (riding hard like I did on the stock motor) If anyone could tell me in like hours or something that would be great.

[Nausty]

Just ride it normal up to half throttle or so for about 20 minutes. Give it a break and just gradually increase in time and throttle. Also don't bog the motor up hills either instead of giving it a little more because thats hard on it too.

[PsychoDave]

i rode it below half throttle for 15 minutes. let the engine cool off and repeated this 3 more times. then i rode the quad like i stole it.

[RED121572]

I cruised up and down dirt roads for two days at about half throttle. My break in time was 6 hours.

Good luck!:)

i rode 20mins of 1/2, cool down 20 mins, 10min of 3/4, cool down 20 mins, fullthrottle for 10 mins(or try) cool down ,Ride like i stole it

i know when i break in a engine i take it easy for a lil over and hour, let it cool down then ride the crap out of it!