cutting fenders

[99_400EX]

i was wondering how and what everyone uses to cut the front fenders on a 400 ex i know of many ways i could do it but i want to know what works best and is the easiest thanks

Jeremy

[airheadedduner]

Jig saw or a bare hacksaw blade. Wrap one end with duct tape so you can hold on easily.

[VegasEx'r]

Dremel. Cuts it & sands it down.

[QuadJunkies]

Use a drehmel,cuts smooth and easy..Also comes with a buffer to smooth out all the edges when your done...

[L.Vegas400]

here is a thread on that exact subject. try the search button.

http://209.120.142.52/showthread.php?s=&threadid=20493

[RiPPiNiTuP7]

I had good luck using a jig saw....so far I did 3 sets of fenders, all with great outcomes :D

[OutlawEX]

yes i also used a jig saw and mine came out looking nice...:devil

[99_400EX]

could you all post some pics of your fenders so i can see how much you all cut off thanks

[loganB]

dremel workes great.

[loganB]

My Fenders.

[phatswinn]

take those knobs off there! it would look alot better

[loganB]

Im geting new plastic eny way I like the nobes.

this is how my race cuts looked, i went back to full fenders though.