jug bolts

[maxoutput]

cant find any torque spec. on the bolts that hold the jug to the case. I am guessing maybe 33 ft. lbs? and the arrow on the piston goes towards the exaust?

[NacsMXer]

Which quad? :confused:

[maxoutput]

400 ex.....now 416:D

[NacsMXer]

The big cylinder bolts on the inside of the motor that actually hold the cylinder onto the lower case get 33 lb-ft according to my Honda manual here. You were right on the money :) :D

[maxoutput]

thanks that is what i was looking for:)

[NacsMXer]

No prob, it's nice having the Honda service manual in PDF format on my computer when I need it :p

[maxoutput]

well its ALIVE,,,,just got done firing it up. It figures the only gasket that i didnt replaced leaked oil (chain tensioner) .
before i put the rocker cover back on i filled everthing up with oil
and cranked it over without the spark plug to get the oil system
primed. seamed to work ok. One thing that i did seam strange
was when i adj. the valves on tdc ( intake .005 exhaust .006 )
when i turned the engine over to hold the exhaust valves open
to ck the adj. on intake, there was .002 - .003 more lash then
what i set it at. This also happened on the exhaust. If i was to adj. the lash this way i think they would be too tight! Anyone
ever ran into this before? 416 11:1 , stage 1 hotcam, new
cam chain. One other thing was the head gasket thickness is
.055 and the old one was .036, guess that 11:1 piston is now 10:5 or 10:1 do you think that it will need to be rejetted?