How To Remove The Bearings Out Of The Stem

[hondabro440]

HOW DO I REMOVE THE BEARINGS OUT OF MY STERRING STEM AREA

[rooster300ex]

Correct me if i'm wrong, but i pretty sure there is a clip ring on the top part of the bearings, take that off with some clip ring pliers or however and knock the bearings out from the bottom. when you put new bearings back in clean it up like new, i used emry cloth to clean it and carb cleaner to blow all the nasty **** out. before you install the bearings put some never sieze in there. it helps the bearings slide in and next time it won't be rusted in there.

http://www.planethondaracing.com/cgi-bin/hondaparts/results_parts_details?mv_session_id=XmN8BtJK&mv_pc=201&se=pg_d_id%3d669%20and%20pg_my_id%3d106

This shows you all the parts. remove both seals,get the circlip out,don't forget about the lil collar on the bottom take that out, and when everything is done put that lil collar back in before you tighten it up.