Get axle bearings out

[BlasterEaten250]

Ok, today we were replacing my axle bearings on my 250, and i have a problem. We cant get the bearing out on the gearcase side, it just won't budge. What can we do to make it easier? Do we need to take it to a welding shop to heat it up? I'm kindof stuck here. Any help would be appreciated.

[1987 trx350x]

make sure its grease free and stick it in your oven on 300* for about 15 min. then try hammering or press it out.

[BlasterEaten250]

Thanks, have you tried this? Anyone else have idea's?

[1987 trx350x]

yes ive done it with my atc 350x's axle bearings. when your ready to press the new bearings in, put the bearings in your freezer for about 4 or 5 hours. Then do the same with the carrier by putting it in the oven, this time maybe 30 min@250*. this will expand the carrier and contract the bearings, making it easy to press in the new bearings.

[Aceman]

Yes, I've done it and it works great. There is a thread on this at the bottom of the FAQ forum.

[BlasterEaten250]

Ok, thanks for all your help guys:cool: