LT Skid plate question

[IrideMHSC]

I have an 03 z-400 with a lonestar +1.25 swing arm and the skid plate on it is old a crappy... I want to get a good heavy skid plate but the bolt patterns dont look the same and the prm i have on my other z has the linkage guard... any one have any suggestions that theyve run into in the past??

[400exrider_ed]

DG Skids have a notched hole pattern so even if your swinger is a 03 or 04+ pattern as long as its a z400 pattern of some type they will fit. LSR was using a universal pattern for awhile on all skids it was 250r or 400ex but I think they switched to oem patterns. Also the linkage is a seperate skid from DG.

[400exrider_ed]

I just read threw some of my old paper work and found my Lonestar Swingarm Set-up sheet from LSR, it states that the skid plate must have new holes drilled out. It must be my Houser swing-arm I switched to that runs oem bolt patterns