Tool?????

[patches85]

Ok so I'm rebuilding my bottom end and in the manual it shows a bolt like thing to pull the crank into the one bearing. What can i use for this?

[spent21]

put your crank in the freezer for a few hours and it will tap right into the bearing. use a piece of brass or perferably a wood block as to not damage your threads.

i have an 88 blazer that i just built. 350 injected, small cam, headers, th350, 4 inch lift, 33 12.50's, with some simulation beadlocks. 11 mpg sucks though.

[patches85]

Yeah thanx for the info. My blazer is just sitting in the garage right now. I gotta paint it. I am in no hurry with gas prices the way they are.

[spent21]

HAHAHAHAHA you had better sell it now then! if you think fuel prices are going to decrease, then you have a long wait in front of you.

Maybe in 30 years you can retrofit it to accept a hydrogen fuel cell, but i'm sure you'll have to have a specially fabricated transfer case