PDA

View Full Version : top end?


theTman
03-31-2006, 04:46 PM
how much would it cost to bring a blown 310cc down to a 265cc?

thanks
250-R-250
03-31-2006, 04:58 PM
I dont think you can, once the cylinder was bored to a fit the 310 sleeve I dont think that you can have it back down.....Enless you know of some wack *** thick 265 sleeve made for just that.

But....figure 250 for a resleeve and portmatch all sent to LA SLEEVE
theTman
03-31-2006, 05:00 PM
haha the cylinder is trashed, it has cracks and etc so i was just wondering
xcracer416
04-01-2006, 08:04 AM
LA Sleeve?? i just got my cylinder back from them and let me tell you i was very dissappointed in thier work. my head stud holes wasnt drilled out, my port match sucked one port on the exhaust was higher than the other, it was rough as hell. i wont ever use them again. my cylinder was origianlly ported my tom miller so i know it was done correct. my opinion find some aftermarket shop to re sleeve it for you
theTman
04-01-2006, 03:07 PM
anyone know how much to redo the top end and keep it a 310?
250R-Dee
04-01-2006, 08:28 PM
If the Cylinder is trashed you will need to resleeve it. Checkout Eric GorrErid Gorr (http://www.eric-gorr.com/), ESR (http://www.esr250.com/), FTZ (http://www.ftzracing.com/), or one of the other two stroke specialist.