PDA

View Full Version : Our LTR450 Photos



FUELATV
03-28-2006, 02:45 PM
Here are some shots of our new LTR450.

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYLTR4507.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYEASTERBUNNY34.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYEASTERBUNNY33.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/BAILEYEASTERBUNNY32.jpg

http://i35.photobucket.com/albums/d169/FUELATV2005/LTR450.jpg

spudss
03-28-2006, 06:03 PM
NICE!!!!!!!!!!!! I like the no graphix look.. And where did you get the quadtech seat.. I want one.. Let me know about that..

FUELATV
03-29-2006, 10:51 AM
Thanks....I got the cover direct from QuadTech. I am going to install graphics. Just waiting to see what comes out.

spudss
03-29-2006, 03:54 PM
What was the cost of the seat cover if you dont mind me asking...

FUELATV
03-29-2006, 04:51 PM
It was $110.00. Too much money IMO but i like the look and it shipped same day. I am a sucker i guess.

spudss
03-29-2006, 06:11 PM
how is it compared to stock.. Is it alot softer??

Tom TRX250R
03-29-2006, 08:17 PM
That is the best LT450 I have seen! I like the clean look of it with no graphics!!

03-29-2006, 08:30 PM
What did you use to get ALL of the glue/adhesive off the plastic after removing the # backrounds?

walty
03-29-2006, 09:28 PM
use spray carb cleaner...i will come off in seconds!!!

Ripitupfilms
03-30-2006, 07:14 AM
thats schit its sick .. i want a zuke reall bad now

FUELATV
03-30-2006, 09:12 AM
Thanks the bike is really starting to come together. Now time for the i-shock long travel setup....
SPUDSS - this is just a seat cover it uses the stock foam. So it is not softer.
I would not use carb cleaner as it might dull the finish on the plastics. I just peeled them off. VERY SLOW and VERY CAREFULL. I Then used simple green to remove any adhesive.

walty
03-30-2006, 11:42 AM
Originally posted by walty
use spray carb cleaner...i will come off in seconds!!!

done millions of times....dont let it soak too long!!!

if you want to clean something and it dont come off...use carb cleaner!!!!!!!!!!!!

so good..it should be in tips and tricks!!!give it a try
i took ALL of my canadian warning sticker of my ltr that way...after peeling the label,use carb cleaner to wipe of the glue

TC440EX
03-31-2006, 08:44 AM
Nice looking Quad. Who's stem and what bend are the bars?

FUELATV
03-31-2006, 09:30 AM
THANKS..... the stem is by us FUELATV, and the bars are TAG cr high bend. The stem is +1 anti-vibe. The TAG bars are about a 1/4 inch shorter then stock. So with this set up your bars will be abou 3/4 inch higher then stock.

TC440EX
03-31-2006, 10:16 AM
How much is the stem?