Leaky Exhuast ............. Need help Fast!!

[bad01300ex]

My exhuast is really leaky right out of the cylinder, it drips oil all over the bottom end. I have only ridden the thing for like 10 minutes cause im rebuilding it right now, but im wondering what i need to do to stop the leaking.

When i pulled the pipe off there was a metal washer sort of thing that came off, but no O rings or anything. Should i order some OEM gasket/oring and some high temp cylicone, i was thinking about getting the ESR billet exhaust flange:confused: It says it uses 2 o rings

any advice would be much appreciated

(its a sparks TT pipe, dont know if that matters)

[FreeStylerEx]

when i had my old 250r it did that stuff, but yeah its your exhaust flange, you can take pipe off and put high temp silicone around it.

[FreeStylerEx]

o yeah, check your jetting

[stever250r]

Get on ebay and buy an aftermarket exhaust flange. There are several types on there.

I recommednt the CFM billet flange. With shipping you can get it for 39.00.

[hondardr4life]

Does the aftermarket exhaust flange help seal better? I was just going to use some hondabond liquid gasket on mine when I put it back together.

[Iliketogofast]

Yeah, you should get that ESR Flange. Also, you should check your jetting, your bike would run better if you were a little leaner.

[Tom TRX250R]

Order the ESR exhaust flange and when you order it make sure to buy about 6 extra hi temp o-rings (orange). Then put hi temp gasket sealer, mine was reddish orange, (you can pick it up at your local auto parts store) and it will not leak a drop afterwards.

[Math]

I was having this problem before. I tryed everything: High temp silicone, exhaust ciment, a type of high temp wool, etc.

The solution is to always replace the asbestos(?) gasket. Honda part number is 18352-HA2-000.
http://servicehonda.com/hard%20parts/atv/trx250r%2086-89/trx250r%20frames%20page.htm
Check the number 7 and 8. The number 8 is the metal ring that go in the groove of the exhaust flange and the 7 is the asbestos(?) gasket. Often people don't know there is a gasket there and they don't replace it. Change it everytime you remove your exhaust and it will never leak.

[bad01300ex]

ordered the ESR flange

thanks for the input

[baseballplaya23]

Do you still need the Asbestos gasket and the metal ring even with the ESR Flange?