View Full Version : Question about 400ex Carb??
I have a few pics of a 400ex Carb. I was wondering if someone on here would let me send them the pics. Then they could use photoshop or whatever and point at where all the adjustments on the carb are. Like the jets, fuel screw, idle screw etc..then email them back to be. I would really apreciate it. Just drop your email if your willing to help me out, and I'll get the pics right over.
Thanks Alot
Tyler
anyone?, could really use the help.
thanks
underpowered
03-24-2006, 03:35 PM
Underpowered@fuse.net iwont be able to get back to you until tomorow though.
no worries, i really appreciate it man.
thanks
tyler
2004exrider
03-24-2006, 05:17 PM
If you didnt send it to him already i can do it for you in a couple of minutes:) Chevrolet95@wmconnect.com
Jimmy
2004exrider
03-24-2006, 06:29 PM
Well i couldnt get your pics to work so i found some for you.
(this pic is with the bottom of your carb taken off) You dont need to take the bottom off to get to the main jet, you can just take off the 17mm cap on the bottom...
2004exrider
03-24-2006, 06:41 PM
Heres the needle, to access it take the top of your carb off. Youll now see the slide which is being held on with an arm, remove the slide from the arm and pull it up your needle is attached to the bottom of it. The lower the clip is on the needle the richer the mixture, the higher you move the clip on it the leaner it will get.
underpowered
03-25-2006, 06:00 AM
well i think he pretty much covered it.
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.