34 tooth rear sprocket

[honda92]

hey does anyone know where to find or if they even make a 34 tooth rear sprocket? i'm looking for a bit more top end and i really dislike running a 16tooth up front without the case saver on. thanks for your help.

[GPracer2500]

Sprocket Specialists (http://www.sprocketspecialists.com/ProductSearch2.aspx) has them down to a 36. 34 is pretty small; might be too small and cause clearence issues between the chain and the sprocket carrier. SS seems to make nearly every size for every bike that will fit without the need for modifications.

good luck

[honda92]

hey thanks a lot, i was also wondering about clearance issues and i took a quick look around and couldn't find anything below 36. i'll check that site out though, thanks.

[curious george]

that quad will have no low end at all with a 34/16 but will go like 90mph.

[curious george]

and will take like 3 miles to get there.

[underpowered]

Originally posted by curious george
that quad will have no low end at all with a 34/16 but will go like 90mph.


Originally posted by curious george
and will take like 3 miles to get there.

not if you have the power to pull it. on a stock or mildly modded 400ex it would be pointless because you could not even get into 5th gear. but on a fully built, stroker, big bore, and all the bells and whilstles motor it would be fine and you would definitally have to shift alot less. what is this bike going to be used for? flat track or tt style racing?

[honda92]

whooaa hold up. i want a 34 because i DO NOT want to run a 16 front. i have a set of 18's and want to run near or a tad higher than stock. so the gearing would be 34/15, that i would like to run if i could find it.