HELP 400ex PROBLEM!!

[ATV_MAN]

I just finished building my 400ex from nothing, it was wrecked and i replaced the frame. The problem i have is that the thing started up fine when i got it done, but the chain was off, so i was gonna roll it to put the chain on and it will not go into nuetral to roll or roll at all. It wont even roll when I engage the clutch. The sprocket doesnt move either when I rev it up. I was wondering what the heck could be wrong. Could the sprocket be binding???? Tranny problems??? I might have placed something wrong................. any ideas or solutions would help.. Thanks in advance

[Castor-426ex]

is your clutch good?
It sounds like sumthin in the gear box if the counter sprocket wont turn or it wont go into gear

[Striker49]

Originally posted by Castor-400ex
is your clutch good?
It sounds like sumthin in the gear box if the counter sprocket wont turn or it wont go into gear

I dont know a whole lot bout clutches but it does sound like your clutch is bad. Did you have it apart when you re-did the rest of your bike?

[Castor-426ex]

well what all have you done to it? you didnt have the tranny apart did you?

[RED121572]

IF you did replace your clutch, the fiber plates and steel plates MUST got together EXACTLY how the shop manual shows.

[ATV_MAN]

I didnt have the clutch apart any, but i didnt adjust on it any, could this be the problem??? i got higher bars and had a hard time connecting it

[ATV_MAN]

I didnt have the tranny apart......

[ATV_MAN]

bump