TC racing +6mm stroker OFFICIALLY FOR SALE CHEAP!!

[400exbiggun]

Here is the deal, before most probably know that I was "thinking" of selling my +6mm tc racing stroker bottom end. I had alot of interest but no one made a offer.
specs its a 76mm crank and rod setup, used about 1 season. It was stripped of the head and cylinder for our other race 426sx bike. Then we started to do a complete rebuild of the motor for tt season. We started to install new crank bearings but never got around to it.
So as the motor sits its COMPLETELY STRIPPED down to the inner case. The inner case's are not split. Every single part is there minus the cylinder, head and piston.

Included is crank, rod, stator, flywheel, good clutch, starter...and all internals including newish t-chain.

Will sell complete or seperate parts.
MAKE ME A OFFER <<<<<<THIS IS THE PART no one seems to get, please do not PM me asking what Im looking to get, if you do it will probably be ignored. I have NO IDEA what they are going for so you'll get a steal. No low-balling, i wont respond to them either.

PICS WILL BE UP TOMORROW.
http://www.imagestation.com/picture/sraid202/pe82375874030ca2fd4be3faf82e0d68f/efeb88c1.jpg
http://www.imagestation.com/picture/sraid202/pa05ebb18211eeff273dbd0569e68b853/efeb8871.jpg
http://www.imagestation.com/picture/sraid202/p1b0dcebf95efd479c0d6683a4666c9e1/efeb882f.jpg
http://www.imagestation.com/picture/sraid202/p69f04d83a5a12b5984a9e22bfc2c8029/efeb8810.jpg

says "TC RACING ENGINES 76MM"

[mtdewracing]

ill give ya 200.00 for it let me know. (not sure if im low balling you or not) rick

[400exbiggun]

actually, thats prob the first offer i recieved...ill post pics tomorrow and take it from there

[mtdewracing]

ok sounds good

[400exbiggun]

here are the following trades also...only trades ill consider

STOCK BERING CARRIER
450R HEADLIGHT OR 06 EX HEADLIGHT
FRONT SHOCKS
REAR SHOCKS
AIRBOX
87MM PISTON (NEW 10:8.1 OR 10:6.1 ONLY)

[400exbiggun]

pix are up

[440_Turtle]

So as i understand it, this is a +6mm TC racing stroker bottom end that needs to be rebuilt with new bearings? what kind of clutch does it have in it? also how are the gears? Very interested.

[400exbiggun]

no it does not need to be rebuilt. WE were just going to replace the crank bearings so it was ready for next race season. But never split the inner case. Only tc racing has even been inside the inner case of this motor. Shifts through all gears fine.

Dont know clutch brand, either barnett or OEM. All fibers are like new thouhg

[Honda5]

I have a lonestar carrier(very good shape)I have another lonestar carrier (put in a swing arm and sitting on my bench, never ridden on) , a set of 450r front shocks(little use but, some of the paint is rubbed off the spring from shockcovers) a rear 450r shock like new , and a rear 400ex shock ok shape.


what can we workout?

[400exbiggun]

PM me if your serious, we can work something out. Very interesetd in those 450r shocks.

[crandles]

What sort of piston does this use?