PDA

View Full Version : Narrowing it down


MXracer16
02-28-2006, 04:58 PM
Since this machine is so wide as it is, how would I go abouts narrowing it? I know about buying the 4:1 offset rims for the front, but what about the rear? Are there any rims that will narrow it down or are my choices an axle or hubs?

Thanks
foxman_23
02-28-2006, 07:36 PM
Putting Z 400 hubs on the rear will narrow it by about 0.5 inches each side. Also can reverse the rear wheels and gain about 1.75 inches total.
ma2cjr
02-28-2006, 07:56 PM
Call Brad @herrmann racing he is in the works for xc a-arms tell him Jesse sent he should be done in a couple of days with mock up . he is useing my bike 2 make the jig he will also have long travil mx and swing arm and stem very soon !!!!!!!!!:) :D
spudss
03-01-2006, 04:09 PM
whats his # I am interested
ma2cjr
03-01-2006, 04:57 PM
1877herrmann
spudss
03-01-2006, 05:41 PM
Where are they located?? East or west coast? How late are they open? I tried to call but just a messege..
tamehart
03-02-2006, 10:10 AM
An East Coast Company. As far as hours I do not know.
KWAD GAWD
03-03-2006, 09:25 PM
Herrmann Racing is in Pennsylvania. They've been a machine shop for years, but just got into the ATV stuff in the last couple years. Not sure if they have any top pros running their components yet, but I've seen some of their work and it looks pretty nice. Try www.herrmannracing.com
Not sure, or do a search, just spell it right. Two RRs, two NNs.