PDA

View Full Version : 426ex


400exrider99
02-20-2006, 07:24 PM
how much would it cost to bore and hone a 400ex cylinder to a 426ex
EX Stud
02-20-2006, 09:02 PM
I just recently paid 60.00
rickmanrider
02-20-2006, 09:47 PM
for it to be put in for you it will cost about $400 give or take a couple of dallers. if go this rout shop around and see how is fastest and cheapest in your area. the kit is about 60.00- 80.00 dallers.
prepracing
02-21-2006, 02:50 AM
$30 to $50 is a good average of getting cylinder bored in my area. Piston is usually around $100, and gaskets $40. So thats $190 for parts. And thats it if u can put it back together yourself. If not then hopefully you could get it put together by a shop for less than $200.
400exrider99
02-22-2006, 03:06 PM
i could instal it my self i just wanted to know how much it would cost for the machining