450r engine/250r frame?

[albi0609]

Im selling my 250r engine .........and im debateing weather to get a new250 or a trx450 engine? how difficult would it be to put that engine in a 250r aren's frame ? and do u think it would be worth doing the work?

[koh0001]

Don't Do it. The motor will not fit with out cuting and refabing the top, and bottom rear frame. Do a search and check some of them out. It's not worth doing unless you just want a project to do. LOL

[250R-Dee]

Don't waste a good 250r frame by putting a 450R slug in it. Just get another 250R motor and build it properly!!

[albi0609]

oh .....idont really dont know then wat to do then..?i almolt killed my self at the track this week because of my engine .......plezz feel free to give me any tips to wat kind od engine to get then ....i can only spend lik 1300$ on a good remliable engine ?

[250Renvy]

What a crying shame waste that would be. What was it about your old motor that made you sell it.?

$1300 could get you a pretty good motor on egay. I assume you want a race motor?

If you want a 450R, just buy a used 450R, it'll probably cost as much as buying a motor and putting it in your R.

[250R-Dee]

What engine do you have? 265 NON-PV with radical porting? Give us some some info!

If your engine hits too hard you might want to start looking for a 265PV or sell your entire quad and get a thumper. Lots of mods are needed to put a 450R motor in a 250R frame.

[Tom TRX250R]

I agree with TRX250RJapan pick up a 265 PV, it will have more smooth power than a light switch power band like it sounds your motor is!