valve train adjustment

[JW450R1]

i have a 04 r.i have a hrc kit installed,pipe port and polish stage 2.i just pulled off my gas tank and checked the valves.i found that the left/side exhaust is .0013,right side is .009.the intakes are both .005-1/2.as per the hrc manual intakes are with-in specs.but as the exhaust there diffently out of specs.could that be causeing my r to stall and be hard to restart even using the hot start?.........

[bozz]

Yes' sell it and geat a yamaha!

[JW450R1]

if i sold my honda and ought a yaammii i would be left in the dust.
look in the other posts and u will see that glen helen honda rules again.my garage is full of hondas.ireally don't think soooooooo.:rolleyes:

[Johnny B]

This is the reason that your quad was starting hard. when i went to ajust my valves, in my 450 they were way off, i mean like 3 thousands on the intake and 4 on the exhaust. i ajusted them to specks and it starts so much easier. and it runs better too.

[QuadRacer041]

Originally posted by JW450R1
i have a 04 r.i have a hrc kit installed,pipe port and polish stage 2.i just pulled off my gas tank and checked the valves.i found that the left/side exhaust is .0013,right side is .009.the intakes are both .005-1/2.as per the hrc manual intakes are with-in specs.but as the exhaust there diffently out of specs.could that be causeing my r to stall and be hard to restart even using the hot start?.........


yes that is why it is hard to start.re shim and youll be good to go.

[JW450R1]

yes,i took it down to honda and they said it's ok:ermm:

[ohsobad_chevy]

Originally posted by bozz
Yes' sell it and geat a yamaha!

You have absolutely lost your mind, fooool!!!

HAHAHAHA Yamaha over a Honda 450 HAHAAHAHAHA

You crack me up.