chain and sprocket kit

[rebelex300]

im looking at getting the pro chain and sprocket kit from magic racing for my 300. it comes with a JT chromoly steel front, JT steel rear and a EK520RX gold x ring chain. what are your opinions on this kit?? the kit cost $79.99. to me it dont sound bad but im not sure about the quality. im dont race or jump hard just ride woods, slate dumps and stuff like that. im just looking for more speed.

[bmf400ex]

ek makes good chains, my preference is for DID for the simple reason i've never had one break on any application. steel sprockets are the best to use if your not racing professionally. $80 is about right for all 3 pieces.

[rebelex300]

will this chain fit with the sprockets out of the box im going with 14-36 gearing, or am i going to have to take links out??

[humblesquirel21]

i just ordered one last night that same setup so we shall see

[rebelex300]

i ordered mine today as well as scott grips, parking brake block off, red/black flame shockwears set i had to stop there before i spend all my money. it looks like a good kit im just hoping i dont have to break the chain and remove links.

[bmf400ex]

Originally posted by rebelex300
will this chain fit with the sprockets out of the box im going with 14-36 gearing, or am i going to have to take links out??

since you went up in front but down in rear your probably close to correct length. it may be a bit long, takeing out links is easy. grinder, and a chain tool.

[humblesquirel21]

what kidna chain tool ike the link spliter or what

[rebelex300]

just got my sprockets and stuff from magic racing today. im very pleased with their sevices and products. just got done riding with the new sprockets and chain....can i say wow! what a difference that made! i have alot more top speed and still have great bottom end accelaration. ill post a pic of my 300 after i wash it. its 60 degrees here and that ground soaked up all that snow. just a bit muddy out:D oh and i have a ? will going from stock tire size 22 to 20 or 18 effect my speed or anything like that and about how much???

[humblesquirel21]

i got mine today to and yes going to 20s will lower ur top speed an increase ur bottom end which is the setup i have with stock gearing i wont no how the sprokets are for a mounth or two because my quad is in pieces for a rebuild magic racing has excelent service i am very very pleased with them in all my buisness dealings big or small

did u have to remove any links

[rebelex300]

no i did not have to. i just tighten the chain just a bit. i mights take a link out so i have more adjustability on my chain but its good now. just the right amount of slack.

[rebelex300]

here is my 300 as of today...i know i need some plastic and grafix.